PAGE 11
INSTALL GUIDE
Setting 1 - Car Finder/ 5th Channel
Menu 2- Alarm Settings
Setting 2 - Secure Program Mode
Setting 3 - Park Light Output
Setting 4 - Horn Honk Timing
1 Car Finder OFF 1 Light Flash Car Finder Mode Disabled
*2 Car Finder ON 2 Light Flashes Car Finder Mode activated when button is held.
1 Parking Lights on Disarm 1 Flash Park Lights on for 30 seconds on disarm
2 Negative Park Light 2 Flashes Switches Park Light and the Trunk Release outputs
3* Normal Parking Lights 3 Flashes 2 Park Light Flashes on disarm
1 5ms Pulsed Output 1 Flash Short (Quiet) Pulses
2 20ms Pulsed Output 2 Flashes Long (Loud) Pulses
*3 10ms Pulsed Output 3 Flashes Normal (Medium) Pulses
1 Secure Program Active 1 Flash Ignition “ON” and Program switch held for 15 seconds
2* Normal Program Active 2 Flashes Ignition “ON” and Program switch held for 5 seconds
Press the Program Switch 2 times
to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program
Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch.
To move to next program step or repeat to change selection.
Press the Program Switch 3 times
to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program
Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch.
To move to next program step or repeat to change selection.
Press the Program Switch 4 times
to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program
Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch.
To move to next program step or repeat to change selection.
NOTE:
To operate the 5th channel on the (640/660 only) and the (606)
buttons, Menu 2, Setting 7 must be programmed for 5th channel output.
Press the Program Switch 1 time
to select setting 1 (This will be confirmed by 1 LED flashes)
Press and hold the Program
Switch until you receive the appropriate # of park light flashes and/or siren chirps.
Release the Program Switch.
To move to next program step or repeat to change selection.
