If the alarm system is triggered while armed, the system will retain in memory
the cause of the trigger. The diagnostics can then be used to determine what
the cause of the trigger was. When disarming the alarm, the siren/horn will
chirp 3 times instead of the usual 2 times to indicate the alarm had been
triggered. The system’s LED will also flash in pulses to indicate which input
triggered the alarm.
NOTE
: LED status will be cleared when ignition is turned ON. For proper
memory clearing, insure to connect the ignition input to the
ignition
on
the vehicle.
Diagnostics
Diagnostics Chart
PAGE 16
INSTALL GUIDE
Additional LED Flashes
While the system is disarmed and the ignition is in the off position, the
LEDs will activate from the following triggers.
1)
If the door is opened the LEDs will stay on until the door is closed.
2)
If the hood is opened the LEDs will stay on until the hood is closed.
3)
If the shock sensor detects vibration the LEDs will turn on momentarily.
4)
If the auxiliary sensor input is activated the LEDs will activate momentary.
Siren Chirps on Disarm LED Flashes Diagnostic
Three Chirps Two Flashes Shock Sensor
Three Chirps Three Flashes Door/Hood Pin
Three Chirps Four Flashes Ignition Input
None Off System Disarmed
None On Solid System in Valet/
Service Mode
None Single Flashes System is Armed
None Rapid Flashes Passive Arming
On/Off Rapid Flashes Car Jack Mode
