PAGE 14
INSTALL GUIDE
Step 1
- Within three seconds turn the ignition ON-OFF-ON-OFF-ON
Leaving ON.
Step 2
- Press and hold the Program Switch - Parking Lights will come ON
**if park-lights do not come on at this point, turn key off for 5 seconds, then
repeat step 1.
Step 3
- Continue to hold the Program Switch, the park lights go out.
(Continue holding switch)
Step 4
- Press the
LOCK
button on each of remote transmitters to be
programmed pause for about 2-3 seconds between each remote. The
park lights will Flash once and the siren will chirp once each time a
new code is learned.
NOTE: Pause for 2-3 seconds between transmitters
All the transmitters
to be used must be programmed at the same time.
All transmitters
not programmed at this time will be erased from memory for
security. The system holds a maximum of 3 transmitter codes.
Transmitter Programming
When the Battery Icon on the remote indicates that the battery is low the battery
should be changed promptly. Replace with quality 1.5volt “AAA” battery.
Battery Replacement
1
1 2
2 3
3
4
4
a
e
r
y
B
tt
Slide
a
tt
e
r
y
B
Lift
Slide
a
te
r
y
B
t
Positive
Negative
The transmitter battery should be changed at least once every year to maintain
proper operating range. Replace with a quality 23A 12volt Alkaline battery.
