3 PIN KEYLESS CONNECTOR
3 PIN KEYLESS CONNECTOR
BLUE
NEGATIVE OUTPUT FOR UNLOCK
RED
12+ OUTPUT FOR DOOR LOCK MODULE
NEGATIVE OUTPUT FOR LOCK
GREEN
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time.
HORN will chip to confirm program mode entered
3 - Select the Program Menu by pressing...
ENTERING PROGRAM MODE
4 - Press and Release the Switch to advance through the settings.
(
Confirmed by HORN chirps & LED flashes)
5 - Press and hold the Program Switch to change the setting
.
(Confirmed by HORN Chirps)
6 -
To exit Program Mode, turn key off.
(Confirmed by Long HORN Chirp)
The Siren will chirp to confirm that the system is in MENU 1
Continue to step 4.
Press Lock
Press Unlock
The Siren will chirp to confirm that the system is in MENU 2
Continue to step 4.
This connector is used when installing the optional keyless entry feature. If the door lock type of
the vehicle is not negative see the following pages for the appropriate door lock diagram.
Pin 1- Green Wire- Negative Lock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
Pin 2- 12volt Output for Door Lock Module
This output will supply 12volts for a plug-in type door lock module. Do not use this input to power-
up relays **LOW CURRENT ONLY**
Pin 3- Blue Wire- Negative Unlock Output
Connect to lock wire from the switch on vehicles with a negative type switch.
**LOW CURRENT ONLY**
1 -
Cycle the Ignition Key On/Off On/Off On (
Leaving the key ON
)
2 -
Press and
RELEASE
the Program Switch 1 time.
(HORN will chip to confirm program mode entered)
3 -
Press and
HOLD
the Program Switch for until the HORN Chirps 3 times.
4 - Turn ignition key
OFF
to exit.
SYSTEM RESET
ENTERING REMOTE PROGRAM MODE
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
1 chirp confirms program mode entered followed by
3 chirps confirming that the system has reset.
1 -
2 -
3 -
Press and release the program switch (The siren will chirp)
**If the siren does not chirp repeat step 1-2.
Hold the program switch until the siren chirps 3 times.
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM/DIAGRAMS
SYSTEM PROGRAMMING -
Menu 1
PAGE 8
450 SERIES
INSTALL MANUAL
SYSTEM WIRING
SYSTEM PROGRAMMING -
Menu 1
PAGE 9
450 SERIES
INSTALL MANUAL
SYSTEM RESET
