ALARM STATUS / DIAGNOSTICS
ALARM STATUS / DIAGNOSTICS
SIREN CHIRPS
LED FLASHES
DIAGNOSTICS / STATUS
3
2
SHOCK SENSOR TRIGGER
3
3
DOOR / HOOD TRIGGER
3
4
IGNITION TRIGGER
0
OFF
SYSTEM DISARMED
0
ON SOLID
SYSTEM IN VALET / SERVICE MODE
0
SINGLE FLASHES
SYSTEM ARMED
0
RAPID FLASHES
PASSIVE ARM COUNTDOWN
LED FLASHES
OUTPUT DIAGNOSTICS
2
LOCK OUTPUT OVERLOAD
3
UNLOCK OUTPUT OVERLOAD
4
TRUNK OUTPUT OVERLOAD
5
STARTER DISABLE OVERLOAD
6
NOT USED
7
AUX 5 OUTPUT OVERLOAD
8
2ND UNLOCK OUTPUT OVERLOAD
If the alarm system is triggered, the system will retain in memory the cause of the
trigger. When disarming the alarm, the siren/horn will chirp 3 times to indicate the
alarm had been triggered. The system’s LED will also flash in pulses to indicate
which input triggered the alarm.
*LED status will be cleared when the ignition is turned ON. For proper memory
clearing, insure to connect the alarm ignition input to the ignition on the vehicle.
If an output from the alarm is shorted the siren
will
chirp
4
times
and
the
park
lights
will
flash
4
times when the system is armed or disarmed. The LED
will
flash a
diagnostic code that represents the circuit that is at fault. (See Chart Below). Turning
the ignition to the on then off position will reset the diagnostic code.
VALET MODE / EMERGENCY OVERRIDE
This feature will disable or re-enable the alarm without the use of the remote transmitter. This
feature will work when alarm in either an armed, disarmed or triggered state. When the system's
override had been activated, door lock and trunk features will still be operational however the
alarm will be active.
Turn the Ignition Key ON
(Leaving the key ON)
Press and hold the valet switch for 8 to 15
seconds (Time depends on "Valet
Settings" Program Option)
2 CHIRPS = OFF
5 CHIRPS = ON
The LED status light will come on "STEADY" to confirm Valet Mode is ACTIVE
The LED status light will be "OFF" to confirm Valet Mode is NOT ACTIVE and system
is in normal alarm operation mode.
Siren will chip 5 times to confirm Valet Mode / Emergency Override
has been activate or 2 times for deactivate (If alarm was in a triggered
state, the siren will shut off and park lights will stop flashing)
ADDITIONAL LED FUNCTIONS
While the system is disarmed and the ignition is in the off position, the
LEDs will activate from the following triggers.
1) If the door is opened the LEDs will stay on until the door is closed.
2) If the hood is opened the LEDs will stay on until the hood is closed.
3) If the shock sensor detects vibration the LEDs will turn on momentarily.
4) If the auxiliary sensor input is activated the LEDs will activate momentary.
SYSTEM PROGRAMMING -
Menu 1
PAGE 14
450 SERIES
INSTALL MANUAL
VALET MODE
SYSTEM PROGRAMMING -
Menu 1
PAGE 15
450 SERIES
INSTALL MANUAL
DIAGNOSTICS
