1
3
5
2
4
6
2
1
4
3
6
5
7
8
10
9
12
11
14
13
Red Wires - +12 VDC Main Power Source Input 30Amp
Connect these two
Red
wires to a main co12 VDC power source.
Black - Chassis Ground
Connect this
Black
wire securely to a clean, solid negative chassis ground.
Blue - Ignition - Sw12 VDC Output 30Amp
Connect this
Blue
wire to the ignition wire sup 12 VDC when the ignition key
Is in the ignition
“On”
and
“Start”
position.
Note:
Many vehicles have 2 main ignition wires which must be connected to ensure
proper operation. See
Ignition2 - Blue/White
wire #3 of the 14 pin harness - 10 amp
Yellow - Starter Output 30Amp
Connect this
Yellow
wire sup12 VDC when the ignition key is in the
ignition
“Start”
position only.
Note:
If installing a Starter Disable Relay, see
Ground O/P Orange
wire #7 of the 14 pin
harness.
Green - Acc12 VDC output - Heater/Air Conditioner - 30 Amp
Connect this
Green
wire to the Accessory wire sup12 VDC when the ignition
key is in the Accessory
“On”
position but not in the
“Start”
position.
6 PIN CONNECTOR
14 PIN CONNECTOR
White: +12 VDC Output for Flashing Parking Lights 15Amp
Connect this
White
wire to positive side of the parking lights wire
.
Red/White: 2nd Channel Output (Trunk Release)
This
Red/White
wire supplies 500ma (-) output when button # 2 is pressed for 1 ½ seconds.
Note:
This can also be used for Driver’s Door Unlock priority.
Blue/White: + 12 VDC Output for Ignition 2 Wire 15 Amp Max
Connect this
Blue/White
wire to the second Ignition wire. (15 amps Max Current).
Brown: Positive Output for Siren or Horn
Connect to (+) brown wire on siren or use relay to connect to (-) Horn
White/Violet: Negative Output while Running
Provides a 500ma (-) Output while remote starter is active
Green: Negative Door Switch Input
Connect to Door Pin switch that is (-) when door is open
Orange - Negative when Armed
Provides a (-) 500ma Output when the alarm is armed
Black/WHite: Tach Input Used only in Tach Mode - See Programming
.
Connect this wire to an A/C tach source
Blue: (+) Bake Pedal Input
Connect this wire to the brake light wire at the brake switch
Gray: Dome-light Output
Provides a 500ma(-) Output for 30 seconds on Unlock/ Disarm
Green / White: Hood Input (-)
Connect to hood pin switch (-) when hood is open
Pink: Factory Disarm
.
Provides a 500ma (-) pulse before start
Yellow: Glow Plug Input (See Programming)
.
Connect this
Yellow
wire to the optional Glow Plug Module for Diesel Glow Plug Mode
Violet: Positive Door Switch Input (Ford Type).
Connect to the door pin-switch, which su12 VDC when door is opened
