PROGRAMMING - Installer Program Mode
This system is capable of multiple programmable functions.
To Enter Installer Program Mode:
1. Open the hood.
2. Turn the Ignition Key
“On/Off”, “On/Off”, “On”.
3. Press & Release the button on the antenna once.
The system will respond with one siren/horn chirp and light flash to confirm it is in Program
Mode and is ready for Feature Programming.
Note:
Upon entering Program Mode you can change as many Modes as you like as long as
you don’t pause for more than 10 seconds between button presses or turn the ignition being
turned
“Off”
To Exit Installer Program Mode
The system will exit Program Mode automatically in the following conditions:
1. The ignition is turned to the
“Off” position
2. No new feature has been programmed within 10 seconds.
Transmitter Button Operation
The transmitter is used in the “Program Mode” as follows:
Button #1 (Lock)
Selects the next lower program feature
Button #2 (Unlock)
Selects the next higher program feature
Button #3 (*)
Selects the setting for the current program feature
Button #4 (#)
Confirms the selected setting via chirps and light flashes
LED INDICATORS
The LED indicators on the antenna with flash in sequence to confirm the selected
programming feature (ie Program feature 4 = 4 LED flashes)
Program Feature
1 Chirp
2 Chirps
3 Chirps
0
1
2
3
4
5
6
7
8
Reset to Default
Tach Sensing Method
Doorlock Timing
Siren / Horn Selection
4th Channel Operation
4th Channel Timing
GM Rearm Mode
Gas/Desiel Selection
Valet Mode Options
Tach Learning
(Must connect Tach Wire)
Tach-less Timer Mode
Tach-Less / Voltage Sensing
3 Second Pulses
Double Unlock Pulse
0.75 Single Pulses
Horn
(Pulsed Output)
Siren
(Constant Output)
4th Channel
Factory Alarm Disarm
Pulsed with Disarm
Latched
Variable
(As Long as Button Is Held)
GM Rearm Mode
Normal Dome-Light Output
Diesel Timer
(10 Second Start Delay)
Diesel Glow-plug Sensing
Normal Operation
(Gas Mode)
IGN
& Valet for 15 sec
Switch Disabled
Ign & Switch for 5 seconds
*** Option in
BOLD indicates default setting****
Back
Forward
Change
Confirm
Press & Hold Valet button #4 for 2 seconds