TACH LEARNING MANUAL TRANSMISSION
Manual Transmission Mode
Note:
Program switch #2 on control unit must be in “ON” position.
In order to start a Manual Transmission equipped vehicle:
Manual Transmission Reservation Mode must be enables each time.
Manual Transmission Reservation Mode.
Step 1
- Leave the Ignition Key in the “On” position (Car is still running).
Step 2-
Press and hold the brake pedal, then press & release button #4.
The system will respond with 1 siren/horn chirp & light flash.
Step 3-
Turn the Ignition Key “Off” - the vehicle should stay running.
Step 4-
Within 20 seconds open and close door (
Note:
The door switch input must
be hooked up).
Step 5-
Within 20 seconds of the door closing, press button #1, the doors will lock
and the vehicle will shut “off”.
Step 6-
The vehicle can now be remote started by pressing button #3.
Note:
If a door is opened, the brake is pressed or the ignition turned “on”, the
vehicle will exit Reservation Mode.
Note:
For increased protection, a Radar Sensor is recommended to protect
anyone from getting near the gearshift if the vehicle is a convertible or if
a window is opened.
Connect the Radar Sensor through relay to the
Green/White
wire hood
safety switch input
Tach learning is optional. It is only necessary if the tach sense option is selected
as the desired start detection method. The black/white tach wire must be connected
to a tach source. The following steps are also necessary for tach learning.
1. Dip switch 1 must be in the off position.
2. The Blue Loop Inside module needs to be cut.
3. Unit needs to be programmed to tach mode. See sensing method in the program guide.
Programming Tach
Step 1.
Enter Installer program Mode.( Ignition On,Off On,Off, On, Leave key On.
Step 2.
Press the antenna button once. Siren and park lights will go on then off.
Step 3.
Select Setting One. (Press the button # 2 twice. LED’s should flash in two’s).
Step 4.
Press button # 3 then start the vehicle with the key.
The system will confirm tach learning by turning the park lights on and chirping
the siren three times.
Note
: If system does not respond, repeat steps as listed above. If unit does not learn
change to a different tach source. Fuel Injectors work best.
Tach Leaning- Method 3
Manual Transmission Mode
