IMPORTANT!
The system must be Tach Learned before remote starting.
The Auto Tach Learn is the same for the TL (tachless) series.
1) Turn the ignition key to the “ON” position. The park lights* will turn “ON”
2) Start the vehicle with the key. The LEDs on the antenna will turn on if a
proper tach signal is detected**, after 30-35 seconds the park lights will flash
and the horn (Optional) will honk twice to confirm Tach Learn.
* If the park lights do not turn on check for proper connection on the BLUE
ignition wire at the 6-pin connector. This wire should be connected to the
vehicle main ignition wire and must not turn off during the start position.
If the ignition connection is correct, reset the system (see System Reset
page 15) and repeat step #1.
** If the LEDs do not come “ON” during tach learn, a proper tach signal
was
not detected.
NOTE:
The LEDs will not turn “ON” for Auto Tach Learn on the TL series.
If the park lights do not flash in Auto Tach Learn mode it may be necessary to
connect to a different tach source. It is important the ignition output from the
remote starter is connected to a wire that does not turn off in the crank position.
The remote starter will not tach learn if connected to the wrong wire.
For best results connect the tach wire to the coil pack or to a fuel injector wire.
New - If the original Tach source is changed a system reset must be
preformed before a new tach signal can be learned to the system.
This does not apply if the Quick Learn feature is being used.
(See page 15 for System Reset).
Your Basic Install Is Complete!
NOTES:
1) If the vehicle does not start when the remote starter is activated, the
park lights will flash a diagnostic code. (See Diagnostic Chart page 24).
2) If the vehicle still does not start, check all connections and check for
factory Anti-Theft system.
INSTALL MANUAL
REMOTE VEHICLE STARTER
PAGE 12
Auto Tach (Tachless) Learn
