ACTIVE RF ANTENNA**
1 2
3
NOTE:
The jumpers control the output from the
WHITE
wire on the
main 6- pin harness. This is an
30amp relayed output
.
*The factory default setting of the Selectable Output jumper is position #3.
Output on White wire Jumper position
Second Starter Position 1
Second Accessory Position 2
Second Ignition Position 3
Status Led’s
Program Button
**The antenna MUST be connected for the system to operate
*
The centre pin of the keyless entry harness is ONLY available with plug-in
devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
1
2
3
1
2
3
4
1
2
3
1
2
Jumpers
Wiring Diagram
REMOTE VEHICLE STARTER
INSTALL MANUAL
PAGE 7
GREEN
WHITE/VIOLET
RED*
BLACK
BLUE
RED
Door Lock Output (-)250ma
Ground While Running Output (-)250ma
12v Output (+)250ma
(see notes above)
*
Ground Output (-)250ma
Door Unlock Output (-)250ma
12Volt Output (+)250ma
(-) Input Trigger (13xx Series Only)
NOTE:
The 2 pin white and 3 pin white auxiliary connectors are not
available on the 12xx series.
