7-3
ELECTRICAL
8. Align the switch tabs (B,
Figure 5
) with
the cutouts in the frame, and press the
switch into place. Make sure the switch
seal is seated in place.
9. Install the battery and battery cap (this
chapter).
CHARGER PORT
Replacement
1. Remove the battery as described in this
chapter.
2. If still connected, disconnect the char-
ger port connector (D,
Figure 1
). Tie a
string to the port half of the connector.
Make sure the string is long enough to run
through the frame. It will be used to pull
the new connector through the frame.
3. Turn out the port screws (A,
Figure 6
).
Remove the charger port (B) and its gas-
ket. Pull the port wire until its connector
emerges from the frame opening. Untie
the string from the connector, but leave
the string in place.
4. Make sure a new gasket is in place on
the charger port.
5. Tie the string to the connector of the
new charger port.
6. While an assistant pulls the string, insert
the wire and charger port into the frame.
7. Secure the port in place with the char-
ger port screws.
8. Connect the charger port connector to
its mate on the switch module (D,
Figure
1
).
9. Install the battery as described in this
chapter.
3. Slide the switch module (A,
Figure 3
) into
the position noted during removal, and
press the wiring (B) into the battery com-
partment.
4. Install the battery cap (this chapter).
KEY SWITCH
Replacement
The key switch is damaged during remov-
al. Have a new switch on hand before
starting this procedure.
1. Remove the battery as described in this
chapter.
2. If still connected, disconnect the key
switch connector (F,
Figure 1
). Tie a string
to the switch half of the connector. Make
sure the string is long enough to run through
the frame. It will be used to pull the con-
nector of the new switch through the
frame.
3. Pull the seal (A,
Figure 5
) from the key
switch.
4. The key switch is held in place by two
tabs on opposite sides of the switch (B,
Figure 5
). Use a small screwdriver to com-
press each tab, and pry the switch from
the frame.
5. Remove the switch, and pull its wire from
the frame port until the switch connector
emerges from the frame. Untie the string
from the switch connector.
6. Make sure a new seal is in place on the
new switch, and tie the string to the switch
connector.
7. Guide the switch wire through the port
as an assistant pulls the string until the
switch connector emerges at the battery
compartment. Connect the switch con-
nector to its mate (F,
Figure 1
).
FIG. 5
B
A
FIG. 6
A
A
B
Summary of Contents for A2B Metro
