UltimateAir 200DX, Manual & Installation Manual

Page: 37 / 52

The UltimateAir® RecoupAerator® 200DX Manual and Installation Guide, March 2014
 

CAUTION
Before performing any service to RecoupAerator, switch off and disconnect
power to the unit. You must disconnect power by either unplugging the unit or
by switching the applicable breaker in your breaker box to OFF. Otherwise, the
main power to the unit will remain hot and could cause serious bodily injury.


Check pre-filters and energy transfer/filtration material every six months or
when the Check Filter light comes on. The Check Filter light comes on every 90
days of continuous operation. Turn off the Check Filter light using the
directions in “Check Filter LED” below.

Clean pre-filters every 3 to 4 months if continuously operated, or every 6
months otherwise.

Replace energy transfer/filtration material when necessary.

Check exterior weather caps regularly.

Lightly vacuum or dust the cabinet interior yearly.

The “check filter” indicator light is located on the front side of the wall
controller and will light up (red) after a continuous operation of 90 days.
Because of differences in indoor and outdoor environments, the filters may or
may not need cleaning/replacement every 90 days. The light is only an
indication to check the filtration material. To reset the light (turn it off), locate
the small hole in the faceplate of your control cover just below the red check
filter light. Using a small-diameter object, such as a paper clip, hold 2 seconds
until the light goes OFF. The light will come on again after approximately 90
days. Check your pre-filters and energy wheel transfer/filtration material for
cleanliness at this time.
To order replacement filtration materials, visit us online at:
www.ultimateair.com