Ugur UBM 20, Instruction Manual

Page: 9 / 10

8
Troubleshooting Continued…..
There is enough water in the
water tank, but the indicator to
“add water” stays on and the
unit will not function.
The water filter on the bottom of
the water tank may be blocked.
Remove the water filter and clean it.
________________________________
After following the procedure outlined in
#8 under the “Using your Icemaker”
section, if your icemaker still does not
start producing ice please try the
following two procedures:
1) Follow the steps outlined in #8,
then wait approximately 5-10
minut
es and press the ‘Power’
button again.
2)
Unplug the unit’s power supply,
wait approximately 5-10 minutes,
plug the power supply back in,
follow the steps outlined in #8.
Ice cube sizes are inconsistent
The ice case panel may not be
level.
Adjust the ice case panel and make sure
it is level.
There is not enough ice cubes
in the ice basket, but the
indicator of “ice full” is on.
The room temperature may be too
low, around 5
℃
___________________________
The ice cubes being formed may
be touching the sensor
occasionally when the ice case
panel pushes the ice cubes into
the ice basket.
Make sure the unit is in an area where
the temperature is above 5
℃
regulated.
_______________________________
Remove the ice cubes, wait for a few
minutes to let the unit restart again.