UFO GEMINI Series, User Manual

Page: 7 / 16

7
UFO LIGHTING
OPERATION
USING THE LIGHT SOURCE
-
GEMINI M MODELS ONLY
Under normal operation the Gemini M light source can be dimmed manually using the dimmer
control on the rear of the unit.
USING THE LIGHT SOURCE
-
GEMINI DMX MODELS ONLY
Gemini DMX light sources can be dimmed remotely, can be switched on/off and can be
addressed manually.
Channel Function Value Description
1 Dimming 0-255 From off at 0 to bright at 255
2 LED & Fan 0-250 LED and fan on
2 LED & Fan 251-255 LED and fan off
Unless the address is specified on the purchase order, all light sources will be defaulted to
address 001. connect the DMX controller to either of the Mini XLR sockets, and the light source
can now be dimmed. Additional slave (which are set to the same address) DMX light sources can
be linked together.
1. Disconnect the light source from the mains supply.
2. Tilt the light source on its side and remove the screw from the base as shown below.
3. Slide the access cover down to remove and set the cover and screw aside.
4. Switch DIP switch 10 (top) to ON as shown below.
5. Replace access cover and securing screw.
REVERTING A DMX LIGHT SOURCE TO MANUAL OPERATION MODE