UFO GEMINI Series, User Manual

Page: 5 / 16

There are 3 connections required – the fibre port, the mains supply cable and the DMX control
cable(s). The fibre port should be connected first. connect and secure the fibre optic connector
into the collar and secure using the M5 locking screw.
connect the PSU to the Dc input jack socket on the light source, and connect the IEc cable to
the PSU. Plug the mains plug into the electrical supply socket. Switch on power the led
indicator will illuminate and the light source is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
connect the DMX control cable(s) to the Mini-XLR sockets on the rear of the light source. The
recommended plug for these sockets is Multicomp SVP556-TA. The pin out details for the plugs
are shown below. Either socket may be used as DMX in or DMX out.
CONNECTION
-
GEMINI DMX MODELS ONLY
Note:
UFO can supply converters for these light sources to allow them to be interfaced to
standard 3 pin XLR connectors or RJ45 connectors.
INSTALLATION
5
UFO LIGHTING