Version 1
8
Trigger on/off trigger switch
The Ultraprobe is always “off’ until the trigger switch is pressed. To operate, pull in and hold the
trigger. To turn the instrument off, release the trigger.
USB port
This port is used to download/transfer information from the Ultraprobe 3000 into the computer. It is
also used
to charge the instrument. Before downloading data be sure the cable is connected to
both the USB port and to the computer. When charging, plug the recharger cable into the USB and
then into the electric receptacle.
Battery compartment
The Handle contains the rechargeable battery. Remove the battery only when it cannot hold a
charge and needs to be replaced. If the battery is to be changed, remove the cover and replace.
Battery
The battery is a rechargeable battery and is charged using the USB port. WARNING: ONLY USE
UE SYSTEMS BATTERY RECHARGER #BCH-3L. DO NOT USE UNAUTHORIZED BATTERIES
OR BATTERY RECHARGERS! Doing so may be hazardous and may damage the instrument and
will void the warranty. Recharging the battery takes about 1 hour; continuous Scanning Module
Stethoscope Module Headphone Jack Sensitivity Control/ Storage Entry Dial Display Panel run
time is about 2 hours. With normal operation (on-off between tests) the charge will last 4-6 hours.
On the BCH-3L BATTERY RECHARGER, when the light is red the battery is charging and when it
is green it is fully charged.
Wrist strap
To protect the instrument, against unexpected droppage use the wrist strap.
Sensitivity/storage entry control dial
This is the most important control in the unit. It is used to adjust the sensitivity. When clicked it
changes functions such as store data or change the storage location number. It is also used to get
into the “SET UP” mode (described later).
Headphones jack
This is where you plug in the headphones. Be sure to plug it in firmly until it clicks
.
