Version 1
15
06 Program Update
Whenever the operating system software is changed, the program can be downloaded off the UE
Systems web site: www.uesystems.com. Upon receiving notice, Download the program to your
computer and follow the procedure supplied by UE Systems.
CAUTION:
Failure to follow t
he “Program Update” procedure may prevent the UP3000 from
programming properly and result in the instrument being shipped back to UE Systems for repair.
07 Exit (to operation mode)
Click the Sensitivity Control dial and you will exit to Operation Mode.
Users instructions
Storing data
Storing data can be performed with either the Normal or Quick store modes. (see Setup Menu 05
Store Data) To Store Data in the NORMAL STORE MODE:
1.
“Click” the Sensitivity Dial to Enter storage mode
2. The Display Screen will show: Storage Location #, Current dB level and a prompt:
STORE/CLICK
3. The Storage Location will blink. You can use this current location or change it. To change the
location “Spin” the Sensitivity Dial to the desired location.
4.
“Click” the Sensitivity Dial and the Storage Location will stop blinking. You will see a prompt:
STORE? YES
5.
To store, “click” the Sensitivity Dial and the data will be stored.
6.
If you do not wish to store the data, “spin” the Sensitivity Dial to NO and “click” to exit.
Scanning module
• Plug in to front end.
• Align the plug located at the rear of the module with the receptacle in the front end of the
Pistol Housing and plug in.
• Start to scan the test area.
Method of airborne detection
The method of air borne detection is to go from the “gross to the fine”. Start off at a high sensitivity
level and if there is too much ultrasound in the area, reduce the sensitivity, following the sound to
the loudest point. If necessary, place the RUBBER FOCUSING
PROBE (described below) over the
scanning module and proceed to follow the test sound to its’ loudest point constantly reducing the
sensitivity while following the bargraph indicator on the display.
Headphones
To use, firmly plug the headphone jack into the “Phones” receptacle on the pistol housing, and
place the headphones over your ears.
Rubber focusing probe
The Rubber Focusing probe fills two functions: it deflects stray ultrasounds and enhances the
reception of weak airborne signals. To use, simply slip it over the front of the scanning module or
the contact module