28
HOW TO USE THE SETUP MENU
There are two ways to enter the Setup Menu:
WHILE IN OPERATION MODE
Click down to move the cursor to the bottom of the Display Screen until PRESS ENTER
FOR is blinking.
Spin to Setup Mode.
Press the Yellow ENTER button.
WHILE THE INSTRUMENT IS OFF
Press both the Yellow ENTER button and the Sensitivity Control Dial at the same time.
Only after these two controls have been pressed, then squeeze and hold the trigger.
NOTE:
Hold the Trigger in during any of the Setup Mode operations.
When in the first Menu mode: Data Transfer, you may move to any of the other Menu
modes by spinning the
Sensitivity Dial up or down (clockwise or counter clockwise).
When the desired Menu mode is reached, click the Sensitivity Control Dial in.
You may Spin and Click to enter and exit any Menu mode in the Set Up mode as long
as the trigger on/off switch is pressed.
MENU 01: ADD/REMOVE SD CARD
Be sure to insert the SD card before turning the Ultraprobe on. The Group data will be
read by the Ultraprobe on power up.
On power down (off), all data and WAV files are stored on the SD card.
The Add/Remove Card function allows users to change the card while the unit is on.
While the power is on, a warning will advise against removal (unless Menu 01 is
selected)
