UDO Super Gemini — Owner’s Manual
68
The Bender
The bender can be used to modulate both the pitch of the oscillators and
the cutoff frequency of the low-pass filter. It responds to horizontal (left/
right) as well as vertical (upwards) movements.
The bender.
A pressure pad is used to measure the vertically applied force and
convert it to a modulation amount. The lever is not designed to be
pushed up in the same way it can be moved sideways.
The section relevant to the bender assignment.
DDS: This fader controls how much the bender affects the pitch of the
oscillators. The maximum pitch-bend range is one octave. The oscillator
selector toggle switch above this control determines which oscillator is
affected by pitch modulation (see
page 71).
VCF: This fader controls how much the bender affects the cutoff frequency
of the low-pass filter. With this fader set to the highest position, the filter
can be fully opened or fully closed when the bender is moved horizontally.
Summary of Contents for SUPER GEMINI
Page 136: ......
