�
EXTREMELY HOT
DO NOT SPRAY
FREON GAS
CAUTION HIGH
VOLTACE
CAUTIONS
DO NOT touch the sleeve heater
or the sleeve during or immedi-
ately after heating them. The hot
surface may cause skin burn.
DO NOT place the Swift KR�� in
an unstable or unbalanced
position. The machine may fall,
causing injury or damage to the
Swift KR��.
The Swift KR��A is precisely
adjusted and aligned. DO NOT
allow the unit to receive a strong
impact. Use supplied carrying
case for its transportation and
storage. The carrying case
protects the Swift KR�� from
damage, moisture, shake and
shock during storage and trans-
portation.
Replace the electrodes in a timely
manner and maintain them as
instructed below.
· Use only a specified electrode.
· Place a new electrode in the
correct position.
· Replace the electrodes as
a pair.
Incompliance with above
instructions may cause abnormal
arc discharge, resulting in damage
to the machine or degradation
in splicing performance.
Use no chemicals other than
ethyl-alcohol (��% or greater)
to clean the objective lenses,
V-groove, V-block, LCD monitor and
body of the Swift KR��.
Otherwise, blurring, discoloration,
damage or performance deteriora-
tion may occur. The Swift KR��
requires no lubrication. Oil or grease
may degrade its performance and
damage the equipment.
DO NOT store the Swift KR��
in a place where temperature or
humidity is high. Damage to the
machine may occur.
belt before transporting.
Transporting the case with a
damaged shoulder belt, it may
cause the damage of the Swift
KR�� and the personal injury.
Make sure to wear protective
glasses while performing splicing
works. If the fiber fragments
come into contact with the eye
or skin, it can be extremely
dangerous.
DO NOT operate the Swift KR��
at a high temperature or near
heat, otherwise personal injury or
damage to the device may occur.
Technical aspects of Swift KR��
should be inspected by a quali-
fied expert. When ignoring this,
it may incur fire or electric
shock. Discuss with UCLSWIFT
Co., Ltd to use the service.
!
FOR YOUR SAFETY
