��
WHEN THE SPLICE LOSS
IS TOO HIGH
HOW TO DEAL WITH THE SPLICING PROBLEMS
It may have been caused by dirt or dust
on the surface of fibers.
HOW TO
· Carefully clean the surface of the fibers.
· DO NOT clean the optical fiber after cutting to prevent
dust rom being gathered on optical fiber’s cross section.
· DO NOT push in the optical fiber when putting is on V-Groove.
Optical fiber should be placed from top to bottom V-Groove.
Bad electrodes
HOW TO
· Keep the V-groove clean at all times.
The arrangement of the fibers can be interrupted
by the dirtin the V�groove.
HOW TO
· Replace the electrodes.
The tips are bent or contaminated if they are worn out.
HOW TO
· Check the set values of arc discharge amount and
arc discharge time and reset them, if necessary.
· The machine is delivered after being set to the most
optimized values from the factory.
Improper arc discharge or arc discharge time.
HOW TO
· Check if the proper splice mode for the fiber
has been selected.
Inappropriate splice mode
