WWDZWx User Manual
Date:9-Jun-2021
Ubitech Ltd.
Version:0.3
13
12
SETUP Z-WAVE NETWORK
12.1 Check Network Status
-
By default, Custos WWD does not belong to any Z-Wave Network, before adding WWD into Z-Wave Network, you have to
make sure Custos WWD is in Standalone Mode, otherwise you have to perform Factory Default Reset refer to 12.4,
-
To check the Network Status of Custos, just trigger Built-in Water Leak Sensor 2 seconds and result as below
i.
In Standalone Mode: the YELLOW LED will be lighted ON;
ii.
In Network Mode: the RED LED will be lighted ON “after included to any Z-Wave Network, Water Alarm will be enabled
as normal function.
12.2 Add Custos WWD into Z-Wave Network
-
Custos WWD supports Security 2 Command Class while a Security S2 enabled controller is needed. It supports SmartStart
and Classic Inclusion;
-
For adding Custos WWD into Z-Wave Network, end-user can use SmartStart for Inclusion.
12.2.1 SmartStart:
-
To enable SmartStart, below methods can be used, please also refer to Gateway’s user manual:
i.
Scan the Z-Wave QR Code or entering PIN Code or DSK String into S2 Enabled Gateway, please refer to item 16.11
SmartStart Labeling, “The QR Code with Full SDK String is printed on packing box”;
ii.
Re-install the battery then SmartStart will be enabled automatically.
12.2.2 Classic Inclusion / Add Device:
-
To enable Classic Inclusion:
i.
Set your Z-Wave Gateway into Inclusion Mode / Add Device processing;
ii.
Trigger Built-in Water Leak Sensor for 2 Seconds;
iii.
2 x Buzzer Sound and 2 GREEN LED ON UI to confirm enter into Inclusion Mode;
iv.
YELLOW LED will be flashing when Inclusion is processing.
