Ubiquiti airFiber 24, User Manual

Page: 12 / 68

8
Chapter 2: Installation airFiber AF-24/AF-24HD User Guide
Ubiquiti Networks, Inc.
5. Click the Wireless tab.
6. Enter the Basic Wireless Settings :
a. For one airFiber AF-24, select Master from the
Wireless Mode drop-down. For the other airFiber
AF-24, keep the default, Slave .
b. Enter a name in the Link Name field. This should be
the same on both the Master and the Slave.
c. For the Duplex drop-down:
-
Half Duplex
The default mode. The TX and RX
Frequencies can be the same or different to suit
local interference.
- Full Duplex The TX and RX Frequencies should be
different.
d. Select a TX Frequency . This must match the RX
Frequency on your other airFiber AF-24.
e. Select a RX Frequency. This must match the TX
Frequency of your other airFiber AF-24.
f. If needed, change the Output Power , Maximum
Modulation Rate , and/or RX Gain settings.
7. Configure the Wireless Security :
a. Select the AES Key Type , HEX or ASCII .
b. For the Key field:
- HEX Enter 16 bytes (eight, 16-bit HEX values: 0-9,
A-F, or a-f). You can omit zeroes and use colons,
similar to the IPv6 format.
Note: The airFiber Configuration Interface
supports IPv6 formats excluding dotted
quad and “::” (double-colon) notation.
- ASCII Enter a combination of alphanumeric
characters (0-9, A-Z, or a-z).
8. Click Change and then click Apply .
9. In-Band Management is enabled by default, so each
airFiber radio must have a unique IP Address . (If the
airFiber radios use the same IP Address , then you may
lose access to the airFiber radios via the Data ports.) To
change the network settings:
a. Click the
Network tab.
b. Change the IP Address , Netmask , and other settings
to make them compatible with your network.
c. Click Change and then click Apply .
Repeat the instructions in the airFiber Configuration
section on your other airFiber radio. After you have
configured the airFiber radios, disconnect them and move
them to your installation site.