Understanding Operation Modes and the Web User Interface
Ubee Interactive
20
Ubee DVW3201B Advanced Wireless Voice Gateway Subscriber User Guide • July 2012
Router
Operates in Router Mode for assigning Static Public IP addresses with RIP when this
mode is enabled. DHCP, Firewall, and NAT functionality are disabled by default. When
Route Mode is enabled, you can configure the device from the Web User Interface (UI)
Routing screen, or through the Telnet Command Line Interface (CLI). Refer to
Using the
Routing Setup Option on page 92
for more information.
NAT Router
Operates in NAT Router mode when enabled. Combines functionality found in both NAT
and Router Modes. You can configure the device from the Web UI Routing screen or
through the Telnet CLI. Refer to
Using the Routing Setup Option on page 92
for more
information.
The following menus show the options available in each mode.
Subscriber Web User Interface in Bridge Mode
Subscriber Web User Interface in NAT Mode
Subscriber Web User Interface in Router Mode
Subscriber Web User Interface in NAT Router Mode
