Operating Instructions
Y
our new automatic pool cleaner contains:
A.
Robotic Pool Cleaner and floating cable.
B.
Power Supply (transformer)
Please
read this Manual completely before operating your Pool Cleaner.
1.
Place the power supply (transformer) at least 3.5 meters (12 feet) from the pool.
(See
figure2).
2.
Uncoil the cable (See figure 3 ).
3.
Make sure that the power supply switch is in the “OFF” position (See figure 4).
4.
Plug the cable into the socket on the power supply (See figure 5):
5.
Place the unit in the water. Turn the unit side to side in the water to allow air to escape from
the
body and then let the cleaner sink to the bottom of the pool (See figure 6 ). Then spread
the
floating cable over the surface of the pool as evenly as possible making sure it is not
tangled
or kinked.
6.
Plug the transformer cord into a 230V~ three grounded outlet (See figure 8).
7.
Turn the transformer ON and adjust the timer according to the operating instructions (see
next
page for details)
3
8
4
2
½
½
Power supply
Power supply
3.5m/12ft
6
CAUTION:
Do not switch
the
pool cleaner
“ON” if it is
not
fully
immersed
in water. Operating the cleaner out of water will cause
severe
damage immediately and will result in loss of warranty. Allow
the cleaner to remain in the pool for 15 to 20 minutes following the
end of its cleaning cycle. This will allow the motors to cool
adequately
. Do not leave the cleaner in the pool all the time. Always
remember
to turn the power supply “OFF” and unplug it from the
power
outlet before removing the cleaner from the pool.
IMPOR
TANT: Please be sure to always keep the cleaner properly stored anywhere between
10 to
40 degrees Celsius (50 to 104 degrees Fahrenheit). This will keep the motor, plastics
and
seals protected. Failure to comply, will result in loss of warranty.
4
4
Large
Small
Lay the floa
ting cable as evenly as possible onto the surface of the water and ensure that the cable is
not caught or kinked.
6. Press the “I“ switch for large pools or the ”O“ switch for smaller pools (see Fig. 7)
7. Plug the transformer cable into the three-pole, earthed, 230V socket (see Fig. 8)
8. Switch on the transformer.
3
Ubbink Manual Robotclean 1 2014_ES.indd 3
07.11.14 13:13
