Filter bag maintenance
label
lock tab
side handle
wheel
tube
The
cleaning cycle of the cleaner is two hours. After two hours of working, the cleaner will shut off automatically by an integrated timer inside
the
unit. In some cases the pools are clean after less than 2 hours and sometimes two hours is not enough. The size and shape of the pool and
the
amount of debris in it, will determine the total time of cleaning. When the cleaner slows down and constantly reverses directions before
reaching
the end sides of the pool, it is sending a signal that it is time to clean or change the filter bag.
CLEAN
THE FILTER BAG AFTER EVERY CLEANING CYCLE
a.
Unplug the power supply. (Please keep the plug away from contact with water)
b.
If the unit is in the pool, gently pull the cleaner toward you using the cable until the
handle
is within reach. Use the side handle (not the cable) or the wheel tube (fig 9) to pull
the
cleaner out of the pool after allowing most of the water to drain from the unit.
c.
Lay the unit on its back on a smooth surface (in order to prevent scratches on the
machine
body), unlock and remove the bottom lid assembly. (fig.10,11,12,13)
d.
Remove the filter bag from the support bars (fig.14), turn it inside out and wash off all the
dirt
with a garden hose or in a sink. Squeeze the bag gently until the rinse water is clear. If
necessary
, machine wash the bag using only cold water with NO DETERGENT!
e.
Re-install the bag on the support bars with the
label
in the center of one of the long
sides
of the bottom lid (fig. 15)
f
.
Re-install the bottom lid assembly in the body. Push down on it until the lock tabs will
snap
into place properly.
CLEANING CYCLE
6
2
3
4
5
6
7
8
9
CLEAN THE FILTER BAG AFTER EACH CLEANING CYCLE
a. Disconnect the mains adapter from the power supply (see Fig. 1). Ensure that
the plug does not get wet.
b. If the device is in the pool, pull it carefully towards you by the cable until the
handle comes within reach. After most of the water has drained off from the
device, pull the cleaning device out of the pool by the handle attached to the
side or the roller (not the cable).
c. Place the device on a smooth, clean surface and remove the top cover (see
Figs. 2, 3 and 4)
d. Remove the filter bag from the holding devices, turn the bag inside out and
wash all dirt off using a garden hose or into a container (see Figs. 5, 6,
7 and 8). Carefully squeeze out the bag until the water runs clear. You can also
wash the bag in the machine on cold wash WITHOUT WASHING POWDER.
e. Reattach the bag to the holding devices and reattach the top cover onto the
housing (see Fig. 9). Press the cover down until the lock tabs engage.
4
Ubbink Manual Robotclean 1 2014_ES.indd 4
07.11.14 13:13
