L
ock Pin
SETTING THE CLEANING PATTERN
A
DJUSTING
T
HE
C
LEANER
FOR
YOUR POOL
T
he
c
leaner
u
se
s
a
s
ystematic
cleani
ng
patter
n
that allows
the
cleaner to go back and fourth in
overlapping patterns. The cleaner
may
be used
to
clean a variety of
dif
ferent size pools, from the small, to
the
very large. Before its first use, you
must
set up the cleaner for your pool.
T
o adjust the cleaner you will use the
axle
locking pin
. (Fig. 17). There are
t
wo
l
ocking
p
ins
p
ermanently
attached to the
unit with a
lanyard.
Only
one
locking
pin
is
required for
most
applications. For the very large
pools you will need to install an
additional
locking pin (Located on the
jet valve housing). Follow the pin
configuration
illustration for your size
pool
(Fig. 18).
1
6
1
8
1
7
Y
our Jet cleaner is pre-set to scan and clean most pools from 70 feet ( 24 m) to 80 feet ( 27 m) in length. The Jet cleaner is factory set
to
look like the picture in Fig.16 with one Lock pin installed on each side. The Jet cleaner will systematically clean your pool in a
consistent
pattern.
After
your Jet cleaner completes its cleaning cycle, remove the cleaner from the pool and transfer the lock-pins
from the right side of
the
unit to the left side (vice-versa) Next time you use your Jet cleaner the cleaning unit will clean the pool in the opposite pattern.
This
will ensure that your cleaner completely cleans your pool.
Lockpin in
preset position
Curves counter
clockwise in this
direction
Adjustable
axle
Fixed
axle
Goes straight
in this direction
Lockpin in
forward position
Curves on a
greater angle in
this direction
Adjustable
axle
Fixed
axle
Goes straight
in this direction
7
5
Ubbink Manual Robotclean 1 2014_ES.indd 5
07.11.14 13:13
