SKU 97706
For technical questions, please call 1-800-444-3353.
PAGE 18
All Vehicles Requiring End Of Line Testing With 1/4”, 5/16”, Or 3/8” Fuel Line
Hose - FIGURE L:
gaUgE
(1)
PRESSURE TESTINg
aND
BLEED-OFF aSSY.
(25)
aDaPTER
(8)
FIgURE L
1.
Turn off the ignition.
Relieve the fuel pressure. Refer to the vehicle’s service manual for specific pres
-
2.
sure relief procedures.
Loosen the hose clamp and disconnect the fuel line.
3.
Install the Single End Barbed Hose Adapter (8) into the fuel supply hose.
4.
Tighten hose clamp securely.
Connect the Gauge (1) to the Pressure Testing and Bleed-off Assembly (25).
5.
Attach the female quick coupler on the Pressure Testing and Bleed-off Assembly
6.
(25) to the male quick coupler on the Adapter (8).
Start the engine and allow it to idle. Check all connections for leaks. Read the
7.
Gauge (1) and compare the result with the pressure values in the service manu-
al.
Stop the engine and turn the ignition OFF.
8.
With free end of bleed-off hose in a suitable container, press button on side of
9.
bleed-off assembly slowly to de-pressurize the fuel system. Refer to the
General
Safety Rules
section before removing tester from vehicle.
Reconnect vehicle’s fuel line and tighten all clamps securely. Check all connec-
10.
tions for leaks.
