SKU 97706
For technical questions, please call 1-800-444-3353.
PAGE 15
Honda, Acura, & Sterling Multi-Port (PGM-FI) - FIGURE I:
gaUgE
(1)
PRESSURE TESTINg
aND
BLEED-OFF aSSY.
(25)
aDaPTER (9)
FIgURE I
1.
Turn off the ignition.
Relieve the fuel pressure. Refer to the vehicle’s service manual for specific pres
-
2.
sure relief procedures.
The test port is at the vehicle’s fuel filter, under the hood, just forward of the fire
-
3.
wall.
The Fuel outlet is secured to the fuel filter by a “double D” bolt. Within this bolt is
4.
a smaller hex bolt that provides access to the test connection.
Place a shop cloth around the fuel outlet and slowly remove the smaller hex bolt.
5.
Screw the small male end of the Honda Adapter (9) into the hole where the re-
6.
moved hex bolt was. Hand tighten.
Connect the Gauge (1) to the Pressure Testing and Bleed-off Assembly (25). At-
7.
tach the female quick coupler on the Pressure Testing and Bleed-off Assembly
(25) to the male quick coupler on the Adapter (9).
Start the engine and allow it to idle. Check all connections for leaks.
8.
Read the Gauge (1) and compare the result with the pressure values in the ser-
9.
vice manual.
Stop the engine and turn the ignition OFF.
10.
With free end of bleed-off hose in a suitable container, press button on side of
11.
bleed-off assembly slowly to de-pressurize the fuel system. Refer to
General
Safety Rules
section before removing tester from vehicle.
Re-install the hex bolt on the fuel filter. Check for leaks.
12.
07f
