Effects
At the bottom of the TWEAKS & FX page are four effect panels: DISTORTION, DELAY, PHASER
and SPRING REVERB:
FX Control
The block at the far left is used for switching and re-ordering the individual effects. Click to switch
on (bright) or off (dark), click and drag up or down to reorder the effects.
Distortion
Bazille’s
Distortion
unit creates traditional tube as well as transistor-type saturation. It can emulate
a complete guitar amp including the speaker cabinet. Tip: You can use the Distortion effect as a
fairly clean EQ if you keep the input level down.
The basic signal flow is:
input amp
→
pre tilt filter
→
distortion
→
post tilt filter
→
post filters
→
output amp
Input
Sets the gain (decibels) at the input, and therefore how hard the input amp is driven.
Output
Sets the gain at the output, and therefore how hard the output amp is driven. Note that there is
a final soft-clipping stage, which can create some extra distortion when turned up ‘too high’.
48