Page 29
To navigate the dimmer configuration menus, the following keys
are used:
•
Adjust Dimmer Number with
Left
and
Right
•
Toggle Dimmer Property with
Up
or
Down
•
Toggle between the Dimmer/Property selection and
property value modification with
SELECT
•
Press
MENU
to exit dimmer configuration
The following properties can be set on this screen:
Channel - This references the “network channel” to which this
dimmer will “listen.” This option is not available on D4100 and
D4200 units. For additional information on the impact of this
settings, please reference “Dimmer to Circuit Patch” on page 27.
Channel should be set to the network channel to which this
dimmer should respond. Usually it’s the same as the dimmer
number, or rather 1-6. In some situations when you have multiple
master stations, you will need each one set to a unique set of
network channels. Valid ranges are 1-2048.
Dimmer Type
The most critical configuration requirement for dimmers is setting
them to the correct load type. For example, if the load type of
your dimmer is Mark X fluorescent, you must set the type to
“MARK X”.
Dimmer type must be set to the appropriate load type to which
this dimmer is connected. The following options are available:
•
STANDARD - Incandescent
•
TU WIRE - Lutron Tu-Wire fluorescent dimming ballasts
•
MARK X - Advanced Mark 10 fluorescent dimming ballasts
•
NON-DIM - Any load type which should not dim. For
example, non-dimming ballasts. A non-dim dimmer only
turns on or off it’s load.
Blink Warn
Indicates whether or not this dimmer should respond to a blink
warn command. Options are:
•
Enabled: dimmer will always respond to a blink warn
