Tytan DS 512, Installation Manual

Page: 10 / 21

10
tytan
Column 8 shows the status of optional equipment: RF module with analogue central door
lock control outputs and external sensor No2 inputs
Lamp Description
RMT_LOCK The lamp shows that LOCK button on Tytan remote transmitter was
pressed
RMT_UNLOCK The lamp shows that UNLOCK button on Tytan remote transmitter was
pressed
RMT_TRUNK The lamp shows that UNLOCK_TRUNK button on Tytan remote
transmitter was pressed
OUT_LOCK The lamp shows that the central door locking analogue control output on
RF module is active - connected to ground
OUT_UNLOCK The lamp shows that the central door unlocking analogue control output
on RF module is active - connected to ground
Press the GPS/GSM Signal button to open the panel with GSM signal strength (CSQ), the
information if the GSM is registered in the GSM network, GPS signal quality (HDOP) and
GPS data: latitude and longitude. The green colour shows the values which are correct for
the device to operate; red colour shows the values which are insufficient for the device
to operate correctly.
Parameter Description
GSM registered Value 1 means that the device is correctly registered in the GSM
network.
GSM CSQ GSM signal strength. Value 0 is weakest. Value 31 is strongest. Value
99 means no signal. Value >5 is sufficient
GPS HDOP GPS signal quality. Value <35 is sufficient
GPS longitude GPS position: longitude
GPS latitude GPS position: latitude
Press the Alarm Memory button. The panel with alarm memory displays last 3 alarm trigger
sources. The memory can be cleared by pressing the ‘Clear’ button.
If the DS512 is equipped with optional RF module, press the RF module button. The test
panel with 2 controls is opened.
The
Save remote transmitters button starts programming procedure of Tytan remote
transmitters.
The
RF module monitor control confirms reception of transmission from
all remote transmitters programmed into RF module. After receiving
transmission from any remote transmitter, the control lights up red for a
second and number of the remote in the RF memory is presented.
Moreover, the controls from the eight column (RMT_LOCK,
RMT_UNLOCK, RMT_UNLOCK) of signal monitor can be used to test
the buttons of remote control.