Tytan DS 512, Installation Manual

Page: 7 / 21

Digital Systems
7
- power windows.
The information which vehicles allow for CAN bus control and which circuits can be activated
is present on the vehicle list and on wiring diagrams
2.6. Audible confirmation of arming/disarming
The parameter enables acoustic signalisation of arming/disarming VSS with short siren
chirps.
IMPORTANT! Audible confirmation can be enabled only in countries where the Reg. 97
does not apply. In opposite case, the homologation of DS512 as a VSS becomes
invalid.
2.7. Power windows roll-up
The parameter enables power windows roll-up when the system is armed. In order to operate
correctly in vehicles with CAN bus power windows control, the necessary level in parameter
5
– CAN-bus vehicle control – must be set.
2.8. Anti-hijack / remote stop enabled
The parameter enables the possibility to initiate anti-hijack sequence - execute remote
vehicle stop via SMS.
IMPORTANT! anti-hijack / remote stop can be enabled only in countries where the Reg.
97 does not apply. In opposite case, the homologation of DS512 as a VSS becomes
invalid.
2.9. GPS receiver
The DS512 can operate as SMS Pager without vehicle localisation or with vehicle
localisation. For vehicle localisation the external GPS receiver must be connected and
enabled.
3. SMS/GSM Paging parameters setup
Press the
GSM/SMS settings button to open the configuration window. The panel allows
to set: VSS PIN, number of mobile phones to notify with SMS when alarming, mobile phones
numbers and information details to be placed in status SMS.
VSS PIN - is a 5 digit PIN code protecting the DS512 against unauthorised access by SMS
commands. The commands are described in DS512 User manual.
Up to three mobile number phone numbers can be set to receive the SMS alarm trigger
notifications from DS512. The numbers should be written in international format with
the
‘+’ or ‘0’ at the beginning, e.g. +44555778899.
The status SMS is sent when the DS512 detects an alarm and as a response to most
of SMS commands.