-9-
-8-
3.3.2 Red LED
When BCP is connected to an external power source (USB or
A/C adapter), the red LED will keep blinking to indicate the
power-on status.
While the unit is powered on, if you hold the scan button for 6-
8 seconds without making any scan, the red LED will stay on
with the green LED flashing constantly to indicate the unit is
now charging. In charging mode, you can continue to use the
unit. Unplug the external power source to terminate charging.
3.3.3 Low Battery Warning (Double Beep)
When the battery power drops below its threshold, BCP will
beep twice in response to a scan press.
3.3.4 Low Memory Warning (Green LED + Triple Beep):
When the unused memory falls under 4KB, in response to a
scan press, the green LED will flash twice together with three
beeps.
3.3.5 Memory Full Warning (Red LED + Continuous Beep):
When the internal memory reaches its full capacity, in response
to a scan press, the red LED will start flashing together with
continuous beeps.
You must download then erase the captured data at this point in
order to resume your operation.
3.2 Utility and USB Driver Installation
3.3 LED Status Indicator
There are two subfolders on the utility/driver CD - BCP Utility
and USB Driver. Run Setup.exe from the BCP Utility folder
and follow the instructions to complete the utility installation.
Windows will prompt you to install a device driver for the
newly detected hardware when you plug in the USB interface
cable to your host PC the first time. Specify the path to the
USB Driver folder and Windows will complete the driver
installation in a few seconds. You only need to run the driver
installation once. Windows will load the driver automatically
the next time around.
Note that USB driver assigns a virtual serial port for
communications. Control Panel > System > Hardware >
Device Manager > Ports (COM & LPT) will lead you to
identify the port number.
BCP uses a dual-color (green and red) LED to show operation
as well as charging status.
3.3.1 Green LED
The green LED will flash once together with a beep to indicate
a successful scan. The green LED will keep blinking while
download operation is in progress and switch itself off upon
completion. The green LED stays on when charging completes.
