TYPHOON Q500 4K, Instruction Manual

Page: 30 / 37

29
GROUND IMAGING SYSTEM
Specifictations
CGO STEADYGRIP™
Height: 223mm (8.78 in)
Depth (front to back): 182mm (7.17 in)
Width: 70mm (2.76 in)
Weight (without gimbal/batteries): 200g (7.05 oz)
Angle Control Range (Pitch): 30° to -85°
Required Batteries: 2850mAh Energizer® 8x 1.5V AA Batteries
(Sold Separately)
Runtime: 48-64 minutes (depending on usage)
Battery Warnings and Usage Guidelines
WARNING: Alkaline Batteries May explode or leak, and cause burn injury if recharged,
disposed of in fire, mixed with a different battery type, inserted backwards or disassem-
bled. Replace all batteries at the same time. Do not carry batteries loose in your pocket
or purse. Do not remove the battery label.
WARNING: All instructions and precautions must be read and followed exactly and you
must follow instructions of the battery manufacturer.
WARNING: procedures, which if not properly followed, create the probability of property
damage, collateral damage and serious injury or create a high probability of superficial injury.
Failure to exercise care while using this product and comply with the following
conditions and guidance could result in product malfunction, excessive heat, fire,
property damage, and ultimately injury.
Lithium lon batteries are not toys. For the purpose of the document Li-lon, Li-Po, Li-Fe,
NiCd or NiMH batteries will be described as "Batteries".
Handling and Storage:
● Never alter, puncture or impact Batteries or related components.
● Do not directly connect the terminals with metal objects. This will short-circuit
Batteries, resulting in heat and electrical discharge.
● Never store loose Batteries together, the Batteries' terminals may contact one
another causing a short circuit.
● Never expose Batteries to extreme temperatures or direct sunlight.
● Always disconnect Batteries when not in use.
Before the First Charge :
● Ensure batteries are not damaged, as this may cause a short circuit of fire.
● Always refer to your charger's manual to ensure safe operation.
● Always charge Batteries in an open area away from flammable materials, liquids and
surfaces.
● Never charge Batteries that are hot to the touch (above 120°F)
If at any time Batteries become damaged, hot, or begin to balloon or swell, discontinue
charging (or discharging) immediately. Quickly and safely disconnect the charger. Then
place the Batteries and/or charger in a safe, open area away from flammable materials
in an approved Li-Po bag to observe. After one hour, remove the Batteries from
service. DO NOT continue to handle, attempt to use, or ship the Batteries. Failure to
follow these procedures can cause damage to Batteries, personal property or cause
serious injury.
Damaged or swollen Batteries can be unstable and very hot. DO NOT touch batteries
until they have cooled. Dispose of batteries in the manner required by your city,
county, state or country. Contact the appropriate Yuneec Product Support Office to
speak to a service technician for more information.
In the event of fire, a Class D, dry chemical fire extinguisher must be used then
batteries must be placed inside of an approved Li-Po bag.
Additional Guidelines and Warnings:
● In the event of a crash, always quickly and safely disconnect and remove Batteries
from the model. Then follow the previously listed safety procedures.
● If the internal contents of Batteries come into contact with your skin, wash the
affected area(s) with soap and water immediately. If it comes into contact with your
eye(s), flush them with generous amounts of water for 15 minutes and seek immedi-
ately medical attention.