TYCROP Manufacturing Ltd.
QuickPass Top Dresser Setup Manual
Page iv
Table of Contents
Figure 26: Rear hopper wall .................................................................................... 12
Figure 27: Folds in hopper wall face outside ........................................................... 12
Figure 28: Install end caps ....................................................................................... 13
Figure 29: Remove hopper mounting bolts from chassis ........................................ 13
Figure 30: Install left and right hopper walls ............................................................ 13
Figure 31: Rear hopper wall .................................................................................... 14
Figure 32: Install rear hopper wall with fold facing out ............................................ 14
Figure 33: Install 6.25 x 15.6 mm (¼ x
⅝
in) Phillips pan-head bolts ...................... 14
Figure 34: Install two rear end caps ......................................................................... 15
Figure 35: Tighten chassis bolts .............................................................................. 15
Figure 36: Install mirror assembly on front right side of hopper .............................. 15
Figure 37: Place spacer and extension against hopper side wall ........................... 15
Figure 38: Mount extensions to hopper ................................................................... 16
Figure 39: Ensure clearance between belt and bottom edge of side extensions .... 16
Figure 40: Apply silicone to sides of extension ........................................................ 16
Figure 41: Install center insert assembly ................................................................. 17
Figure 42: Pull motor from mounting position .......................................................... 18
Figure 44: Slide out belt cartridge assembly ........................................................... 18
Figure 45: Remove belt tensioning bolts ................................................................. 18
Figure 46: Remove rail from end of roller ................................................................ 19
Figure 47: Pull rollers out of belt .............................................................................. 19
Figure 48: Slide new belt over cartridge .................................................................. 19
Figure 49: Thread tensioning bolts into roller shaft ................................................. 20
Figure 50: Slide belt cartridge back into main body ................................................. 20
Figure 51: Remove bolts from walking beam suspension’s bearings ..................... 21
Figure 52:Turn off fuel tank’s on/off valve ............................................................... 21
Figure 53: Remove mounting bolts for fuel tank ...................................................... 21