Document No: LT0499
RDU Mk2 Installation & Programming Manual
Programming Part 1
Issue 1.02
8 April 2015
Page 6-21
S
40 character site name
(blank lines are allowed)
Z1
Example text name for zone 1
Z2
Name for zone 2
Z3
This name has leading spaces
Z4
This name does not have leading spaces
.
.
.
Z23
This name will be cut at 30 characters as it is too long
Z24
Name for zone 24
A1
Name for ancillary 1 relay
A2
Name for ancillary 2 relay
A3
Name for ancillary 3 relay
F
Phone TYCO FIRE SYSTEMS 7903600 (40 characters max)
<blank line>
To initiate the loading of the file into the RDU, enable remote text entry as described above.
Run a terminal emulation program on the PC and press ENTER on the PC.
When the message:
Enter Znnn, An, S, F, P, Q :
appears, send the file containing the text names to the RDU using the "send file" command
of the terminal emulator. If possible set the terminal emulator to use XON/XOFF flow control
or else set the line transmit delay to 100 milliseconds. After loading the text names, exit
program mode and do a database print to check that all names have been assigned
correctly.
6.4.4
GLOBAL DATA
Option 3: Global data from the main program mode menu provides access to a series of
menus that allow a number of different options to be set. The following set of menus shows
the options that are found in these menus. The right arrow key is used to step to the next
menu. The left arrow key or clear key are used to go back to a previous menu. Sections
6.4.4.1 to 6.4.4.13 describe all of the parameters that appear in the following menus.
1:FF options 2:Capture FIP options 3:Pass-on/Follow FIP options 4:MCP >
Option 1 "FF options" is described in section 6.4.4.1.
Option 2 Capture FIP options is described in section 6.4.4.2.
Option 3 Pass-on/Follow FIP options is described in section 6.4.4.3.
Option 4 MCP is described in section 6.4.4.4.
Pressing the right arrow key from the above menu produces the following menu:
1:Brigade test 2:All Zones isolated 3:Printer setup 4:Common LEDs >