KANGAROO JOEY
™
10
Enteral Feeding Pump
loading Pump sets
The KANGAROO JOEY Enteral Feeding Pump will indicate
LOAD A SET
in the screen’s status line if a pump set is not installed. A
blinking icon of a pump set will also appear in the upper left corner of the screen. Figure 5A shows the screen for continuous feeding
mode and Figure 5B shows the screen for intermittent feeding mode (intermittent feeding mode not available in EZ Pump Mode).
figure 5a.
LOAD A SET
opening menu
screen for Continuous feeding mode
(eZ Pump Mode not activated).
figure 5b.
LOAD A SET
opening menu
screen for Intermittent feeding mode
(eZ Pump Mode not activated).
To load a Pump Set, follow the steps below:
1. With the pump display facing you, open the blue transparent door that encloses the rotor and pump set loading area.
2. Load the pump set by holding the finger tab on the valve, then inserting the valve into the valve slot on the left. (Figure 6A)
3. Grasp the MISTIC retainer end (black ring retainer) and wrap the tubing counterclockwise around the rotor.
avoid overstretching the silicone tubing. (figure 6b).
4. Carefully pull the MISTIC retainer end left and upwards to position it over the slot on the left, and then lower the retainer into
the slot. Push down on the retainer then release to ensure proper engagement. (Figure 6B)
5. Push the valve’s finger tab to the right to ensure proper seating.
6. Close the blue transparent door, checking to make sure the valve finger tab is captured by the slot in the blue door.
NOTE: To avoid nuisance alarms, make sure the pump set exterior is free from droplets of water or formula.
7.
The top of the starting volume of formula should be 6 inches above the pump (figure 4b).
figure 6a.
figure 6b.
4FU-PBEJOH%PPS
1VNQ4FU
7BMWF
1PXFS
#VUUPO
'JOHFS5BC
.*45*$
3FUBJOFS
&OE
7BMWF4MPU
3FUBJOFS4MPU
The display should read
SET LOADED
and will show one of the following opening menus, depending on the type of pump set
detected, and whether continuous or intermittent feeding mode has been selected.
