Illustra Pro Series 5MP, 3MP & 2MP Mini Dome Series
13
Mount using the Pendant Cap (Outdoor)
If mounting the camera using the pendant cap you must ensure that the cable seal connector is used
and that the wires are shaped as in the image below. This will allow any moisture that may gather to
run off without entering the enclosure base assembly.
Figure 6
1. Pierce a small hole through the base seal of the enclosure base assembly at the
corresponding screw hole to allow the screw to be inserted. Only pierce the holes needed for
the installation as this will maintain the waterproof seal.
2. Cut off the top of the required boots.
3. Insert the cable seal connector in the conduit hole on the camera base and secure. If
required the torx key can be placed horizontally in the space provided on the seal connector
and turned to ensure a tight seal.
Figure 8
4. Feed the wire/s through the corresponding boot of the cable seal connector on the enclosure
base assembly.
5. Shape the wires as seen in Figure 6. This will allow any moisture that may gather to run off.
Boot has been
cut so wire can be
inserted
Uncut boot
Figure 7
