Illustra Pro Series 5MP, 3MP & 2MP Mini Dome Series
12
Mount Using a Junction Box (Indoor)
1. Tie your wiring into a junction box and feed the wires through the top conduit hole on the
enclosure base assembly.
2. Tighten the screws to secure the enclosure base assembly to the junction box. Then connect
the wiring.
3. Align the camera base assembly with the enclosure base assembly using the green dot as a
guide. Insert the camera base assembly and then fasten the TP4 screws into the inserted
anchors.
4. Aim the camera to the area of interest by rotating and panning the camera base. When
rotating the camera base, do not rotate it past the stop point. When desired orientation is
achieved tighten the two pivot screws to secure.
5. Fit the camera liner over the camera assembly so that it snaps into place.
6. Use the supplied security torx key to tighten the three cover screws to secure the bubble
assembly.
7. Finally, insert the screw hole covers to cover three screws in the bubble assembly.
Mount Using a Junction Box (Outdoor)
1. Pierce a small hole through the base seal of the enclosure base assembly at the
corresponding screw hole to allow the screw to be inserted. Only pierce the holes needed for
the installation as this will maintain the waterproof seal.
2. Tie your wiring into a junction box and feed the wires through the top conduit hole on the
enclosure base assembly.
3. Tighten the screws to secure the enclosure base assembly to the junction box. Then connect
the wiring.
4. Align the camera base assembly with the enclosure base assembly using the green dot as a
guide. Insert the camera base assembly and then fasten the TP4 screws into the inserted
anchors.
5. Aim the camera to the area of interest by rotating and panning the camera base. When
rotating the camera base, do not rotate it past the stop point. When desired orientation is
achieved tighten the two pivot screws to secure.
6. Fit the camera liner over the camera assembly so that it snaps into place.
7. Use the supplied security torx key to tighten the three cover screws to secure the bubble
assembly.
8. Finally, insert the screw hole covers to cover three screws in the bubble assembly.
