Tyco ADT16E, User Manual

Page: 59 / 83

Digital Video Recorder
49
DVRNS (DVR Name Service) Setup
DVRNS allows the DVR to use dynamic IP addresses for remote connection. The DVRNS Setup screen
allows you to configure the DVRNS server and register the DVR to use DVR name service.
Figure 66 — DVRNS Setup screen.
Highlight the box beside
Use DVR Name Service
and press the button to toggle between
On
and
Off .
Highlight the box beside
DVRNS Server and enter the IP address or domain name of the DVRNS server.
NOTE: You will need to get the IP address or domain name of the DVRNS Server from your
network administrator.
NOTE: You can use the domain name instead of the IP address if you already set up the DNS
Server during the LAN Setup.
Highlight the box beside
Port
and enter the port number of the DVRNS server. The port number can be
set from 10000 to 12000.
NOTE: The DVRNS server settings on your DVR should match the settings on the registered
DVRNS server. Any changes on the DVRNS server might cause improper operation.
Highlight the
Use NAT
box and press the button to toggle
On
and
Off
. Turn on Use NAT when the
DVR is networking using the NAT (Network Address Translation) device.
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’
instructions for the proper network settings.
Highlight the box beside
DVR Name
and press the button to name the DVR to be registered on the
DVRNS server. A virtual keyboard allows you to enter the DVR name.
Selecting Name Check allows you to check whether or not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Name Check , otherwise the DVRNS
changes will not be saved.