4. Apply red sealant.
Apply one layer of red sealant onto the cable jacket as shown.
;;
;;
;;
One wrap
Red Sealant
237
5. Apply red sealant.
Bring the braids forward and temporarily tape them to the
PILC cable to hold them in position.
Press the braids onto the sealant. Apply one layer of sealant
directly over the braids and the first layer of sealant.
;;
;;
;;
;;
Tape
One wrap
Red Sealant
238
PCN 307937-000
Effective Date: March 13, 2007
PII 54917, Rev AJ
17
8. Apply red sealant.
When the breakout has cooled sufficiently to touch, apply one
wrap of red sealant to the body of the breakout.
;;
;;
;;
One wrap
Red Sealant
239
7. Position non-conductive sealing breakout; shrink in
place.
Position the breakout on the poly cable semi-con, with the
fingers clear of the neutral wires and the body over the three
splices.
Shrink in place starting with the fingers and working toward
the splice center.
;;
;;
;;
;;
Sealing Breakout
233
6. Apply shield mesh.
Starting at the poly cable semi-con, wrap one half-lapped layer
of 2-inch
(50mm)
wide shielding mesh across the splice and
solder to the PILC cable lead sheath.
;;
;;
;;
Copper Shielding Mesh
232
9. Position wraparound sleeve.
Remove or tape over all sharp points to prevent puncture of
wraparound sleeve. Remove backing from the wraparound
sealing sleeve and center sleeve over splice. Slide metal
channel onto butted rails.
Retention Clip
Black Wraparound Sleeve
442
