5
For slotted core cable only
4.1.3.1 Install a protection tube of 150 mm over the fibers of each slot
and slide it into the slot of the cable.
4.1.3.2 Protect the transition from the cable to the tubes with a few
layers of Teflon tape.
4.1.3.3 Consider the protection tubes now as loose tubes in the
installation.
4.1.1.
Feed the cable through the cable port gland.
4
Cable installation
4.1
Cable preparation
4.1.2.
In case the cable diameter does not match with the diameter
of the gland seal, remove the plastic nut, metal ring and rubber seal
inside the gland and peel out some of the break out rubber rings up to
the right diameter.
4.1.3
Prepare the cable according to the drawing, Strip and clean
the cable over a length of 1800 mm. and cut the strength member at
60 mm length.
1800 mm
60 mm
