4
3.5.1.
Place the template against the wall and mark the selected
mounting positions onto the wall.
3.5.2.
Drill the holes (diameter. 6 mm, depth 60 mm) and place the
plugs into the holes.
3.5
Mounting of the box on the wall
3.5.3.
Hold the base part onto the wall. Insert the screws and tighten.
3.4.1
Install the splicing tray by pushing the lip on the groove plate
slightly up with the tray and move the tray lateral from left to right into
the hinging cavity.
Note
.
1 for single element start on the second position
leaving one position open between each of the trays.
2 For ribbon 4-8 trays the tray hinges have to be
inserted from right to left.
3.4
Installation of the trays
3.3.1.
Take the groove plates and slide the long protrusions into the
left bracket of the UMS bracket.
3.3.2.
Pull on the long snapfit towards the profile till it clicks in the
UMS bracket, start on the FAS block without leaving gaps between the
plates.
3.3
Installation of wraparound groove plates
