408-10289
Surface Mount Module Kits 1933668-[ ], 1933671-[ ], and 1933674-[ ]
3 of 4
Rev A
Tyco Electronics Corporation
3.2. NEMA Electrical Box and European Mounting Base
(4- and 6-Port Module Kits Only)
1. Align the module base mounting holes with the
screw holes in the electrical box or mounting base.
2. Thread, then hand–tighten screws (customer
supplied) until the module base is secure to the
electrical box or mounting base.
4. ASSEMBLY PROCEDURE
4.1. Route the Cable and Install the Jacks and
Multi-Media Inserts
1. Route the cable(s) through the through–wall
cable entrance and/or raceway cable entrance of
the module base (shown in Figure 1), and
terminate the jacks or multi–media inserts to the
cable according to the instructions packaged with
the product.
For fiber optic applications, route the cable through
the fiber optic cable guides.
NEVER place cable under tension or torsion.
Dress cable using the minimum bend radius and
maximum tensile loading as recommended in
Electronic Industries Alliance (EIA) 568.
2. Coil excess cable around the inside of the
module base. Retaining walls of the fiber optic
guides can be deflected outward to assist in
dressing the cable.
3. From the inside of the module base, align the
jack or multi–media insert with the appropriate port
of the modular base. Make sure that the movable
latch is facing UP (away from modular base).
Insert the jack or multi–media insert, at a slight
angle, into the port then rotate it upwards until the
movable latch snaps into place. Repeat this step
for the remaining jacks or multi–media inserts.
Refer to Figure 5.
4. Using the cable ties, secure the cable to the
cable tie–downs.
To avoid distortion or damage to the cable,
DO NOT over-tighten the cable ties.
4.2. Install the Cover
1. If using raceway(s), proceed as follows:
a. Use a sharp instrument to scribe the
appropriate break–out(s) of the cover, then
remove the break–out(s). Refer to Figure 6.
b. Install an appropriate–sized raceway(s)
(customer supplied) onto the break–out(s)
according to manufacturer recommendations.
NEMA is a trademark of National Electrical Manufacturers
Association Corporation.
Figure 5
Port
Jack or
Multi-Media Insert
Movable Latch
FacingUP
Jack or Multi-Media
Insert at Angle to Port
Movable Latch
Snapped" into Place
Rotate
1
2
Figure 6
Side View of Cover
Bottom View of Cover
Break-Out
Break-Out
Break-Out
Back of Cover
Opening
(Ref)
Opening
(Ref)
CAUTION
!
CAUTION
!
