408-10289
Surface Mount Module Kits 1933668-[ ], 1933671-[ ], and 1933674-[ ]
Rev A
4 of 4
Tyco Electronics Corporation
2. Align the opening of the cover with the ports of
the module base, and push the cover onto the
module base until all of the locks engage and the
bottom of the cover is against the mounting
surface. See Figure 7, Detail A.
3. Thread the cover screw into the hole in the top
of the cover; tighten the screw until it is snug and
the head of the screw is below the surface of the
label holder. See Figure 7, Detail B.
4. If desired, write on the identification label, then
lay the label into the label holder, and install the
cover onto the label holder.
Figure 7
Opening of Cover
Aligned with Ports
of Module Base
Full Perimeter of
Bottom of Cover
Against Mounting
Surface
Detail A
Detail B
Icon(Optional)
Cover Screw Installed
(Head Below Surface)
Label and
Label Cover
Note: Cable Not Shown
Installing Cover
5. If desired, install icons into the icon holders for
port identification.
5. REMOVAL
5.1. Removing Cover
1. Remove the label cover and label from the label
holder of the cover.
2. Remove the cover screw from the top of the
cover.
3. Insert the tip of a small flat instrument into either
slot located on the sides of the cover, and twist the
instrument until the cover disengages. Do the
same with the other slot. Then, lift the cover off of
the module base.
Figure 8
Slot (2 Places)
Cover Screw
Removed
Removing Cover
Note: Cable Not Shown
5.2. Removing Jack or Multimedia Insert
1. Place the tip of a small screwdriver under the
movable latch of the jack or multi–media insert,
then pry the tip downward slightly until the latch
partially disengages.
2. Rotate the jack or multi–media insert away from
the port until the latch is fully disengaged; then
remove the jack or multi–media from the port.
6. REPLACEMENT
DO NOT use any defective or damaged components.
7. REVISION SUMMARY
S
Initial release of instruction sheet
