408-10289
Surface Mount Module Kits 1933668-[ ], 1933671-[ ], and 1933674-[ ]
Rev A
2 of 4
Tyco Electronics Corporation
management. The module base provides 3 mounting
options: holes that accept the self–tapping screws,
adhesive foam tape—both for mounting to a flat
surface, and magnet holders that accept magnets
(available separately) for mounting to a ferromagnetic
surface.
The cover features embossed port identification
numbers, icon holder for each port, and a label
holder. The cover has break–outs on the sides and
back that accommodate commercial raceways (not
included).
3. MOUNT THE MODULE
3.1. Flat Surface
A. Using Foam Tape
(Included with Module Kit)
1. Remove the protective adhesive paper from one
side of the foam tape, and place the foam tape on
the bottom of the module base. Recommended
location is shown in Figure 2.
2. Remove the protective adhesive paper from the
foam tape, and place the module on a flat surface.
Press the module to secure the foam tape.
B. Using Self-Tapping Screws
(Included with Module Kit)
1. Position the module base on the flat surface at
the desired location. Mark holes on the surface
using the mounting holes of the module base, then
remove the module base. Refer to Figure 3.
The 2-port module base has 2 mounting holes,
and the 4- and 6-port module bases have 6
mounting holes.
2. Drill the holes into the surface. If required, install
screw mounting anchors (customer supplied).
3. Align the mounting holes of the module base
with the drilled holes or mounting anchors. Install
the self–tapping screws, then tighten them until the
module base is flat against the surface.
C. Using Magnet 1933677-1
(Available Separately)
1. Slide a magnet under each magnet holder on
the top of the module base as shown in Figure 4.
The 2-port module base has 1 magnet holder,
and the 4- and 6-port module bases have 2
magnet holders.
2. Place the module onto a flat ferromagnetic
surface.
Figure 2
Foam
Tape
Recommended Location of Foam Tape
(Bottom of Module Base)
2-Port Module Base
4- and 6-Port Module Bases
Ports (Ref)
Foam
Tape
Ports (Ref)
Figure 3
Self-Tapping Screws Location
(Top of Module Base)
2-Port Module Base
4- and 6-Port Module Bases
Ports (Ref)
Ports (Ref)
Mounting Holes
(2 Places)
Mounting Holes
(6 Places)
Figure 4
Magnet Location
(Top of Module Base)
Magnet
Holder
2-Port Module Base
4- and 6-Port Module Bases
Magnet Holder
(2 Places)
Ports (Ref)
Ports (Ref)
NOTE
i
NOTE
i
