en
26
Installation
Indications,
functions and options
Messages
Commissioning
Operation and function
4.9
Basic settings
In the Basic settings menu, all basic parameters for the controller can be adjusted.
Normally, these settings have been made during commissioning. They can be subse-
quently changed in this menu.
Adjustment chan-
nel
Description
Adjustment range / se-
lection
Factory setting
Language
Selection of the menu language
Deutsch, English,
Français, Español, Italiano
Deutsch
Auto DST
Daylight savings time selection Yes, No
Yes
Date
Adjustment of the date
01.01.2001 … 31.12.2099 01.01.2012
Time
Adjustment of the current time 00:00 … 23:59
-
Targ. temp.
Target temperature control
30 … 70 °C
60 °C
Reset
back to factory setting
Yes, No
No
4.10 MicroSD card
SD card
Adjustment channel Description
Adjustment range / selection Factory setting
Rem. time
Remaining logging time -
-
Options
Remove card...
Safely remove card
-
-
Save adjustments
Save adjustments
-
-
Load adjustments
Load adjustments
-
-
Logging int.
Interval for data logging 00:01 … 20:00 (mm:ss)
01:00
Logging type
Logging type
Cyclic, Linear
Linear
The controller is equipped with a MicroSD card slot for MicroSD memory cards.
With a MicroSD card, the following functions can be carried out:
• Logging measurement and balance values. After the transfer to a computer, the
values can be opened and visualised, e.g. in a spreadsheet.
• Store adjustments and parameterisations on the MicroSD card and, if necessary,
retrieve them from there.
• Running firmware updates on the controller.
Firmware updates
When a MicroSD card with a firmware update is inserted, the enquiry Update? is
indicated on the display.
Î
In order to run an update, select Yes and confirm with the right button (
✓
).
The update will run automatically. The indication Please wait... and a progression
bar will appear on the display. When the update has been completed, the controller
will automatically reboot and run a short initialisation phase.
Note:
Only remove the card when the initialisation phase has been completed
and the main menu is indicated on the controller display!
Î
To skip the update, select No.
The controller starts normal operation.
Summary of Contents for tubra-eTherm
Page 123: ...27 fr...
