SD Card Stat (page 10/11)
Another short press of the LEFT key brings up this screen showing information about usage of the
memory on the Micro-SD card.
Calibration (page 9/11)
LEFT again brings up the screen that allows the firmware to recognize the limits and centering of the
sticks, as well as the limits of the three pots (potentiometers).
Just follow the instructions on-screen, pressing MENU to start, then centering the sticks and
pressing MENU again. Finally, move the sticks to their full extent in all directions (don’t press hard
against the stops) and twist the pots through their full range. Press MENU again and you’re done.
NOTE: It is
essential
to calibrate the transmitter initially and whenever there are any changes that
could affect the stick or pot outputs (e.g., replacement of a stick assembly). With the 9XR Pro (unlike
the 9XR) the calibration data are stored in General Settings, separate from model memories.
ANA (Analog Inputs) (page 8/11)
Another short press of the LEFT key brings up a screen that shows the analog inputs (sticks, pots
and battery voltage) in hexadecimal format to save space.
Ersky9x Explained – version 1
page
12
of 45
