the TELEMETRY 2 screen as the mAh Alarm. The capacity calculation is made in steps
of 64 mAh. The display will change accordingly.
T1, T2
: Temperature sensors 1 and 2
Spd, Dist, GAlt
: GPS speed, distance from starting point and GPS altitude
Cell
: Lowest cell on FLVS-01
Cels
: Sum of all cells on FLVS-01
Vfas
: FAS-40/100 voltage measurement
Curr
: Current, source configured in the settings above (FAS or analog)
Cnsp
: mAh consumed in total (needs current source configured correctly)
Powr
: Power, voltage and current sources configured above
AccX, Y, Z:
Acceleration values from TAS-01
Hdg:
GPS heading
Vspd:
Vertical speed (either calculated by the radio or reported by the sensor, depending
on the sensor type chosen above)
In the custom telemetry display, when pressing LONG MENU:
If ALT is displayed, set to 0.
If A1 or A2 is displayed, and is measuring current, use the present value as an offset,
thus setting the displayed value to zero.
If a SCALER is displayed (see page 43) and its source is ALT, the ALT value is used as
an offset to set the ALT value displayed to zero.
The following is an example of a custom telemetry page:
Templates (page 12/13)
The templates are "starting points" for model setups. When selected with MENU LONG they will
either add to or replace the current model's mixes and settings with standard ones for a particular
usage scenario. They are best applied to a newly created model. They can be tweaked to achieve
the desired result, or simply used to get an idea of what's required for the particular model type.
Ersky9x Explained – version 1
page
40
of 45
